Reasons for abnormal sound of ultrasonic rotary vibrating screen
The ultrasonic rotary vibrating screen is equipped with an ultrasonic system on the basis of the rotary vibrating screen. The unique screen cleaning device can effectively solve the phenomenon of static electricity and agglomeration of materials, and effectively solve the problem of difficult screening of small and micro-particle materials. Very good screening effect.
Professionals from Xinxiang Dayong Vibration Equipment Co., Ltd. pointed out that some manufacturers of the rotary vibrating screen in the market said that the ultrasonic rotary vibrating screen runs for a long time, and sometimes abnormal noise occurs. This article analyzes the possibility of abnormal noise in the ultrasonic rotary vibrating screen. Causes.
If you have other questions about the vibrating screen, you can contact us, and the professionals of Dayong Vibration Equipment Company will give you solutions.
The ultrasonic rotary vibrating sieve is equipped with an ultrasonic system on the basis of the rotary vibrating screen. The unique screen cleaning device can effectively solve the phenomenon of static electricity and agglomeration of materials, and effectively solve the problem of difficult screening of small and micro-particle materials. Very good screening effect.
Professionals from Xinxiang Dayong Vibration Equipment Co., Ltd. pointed out that some manufacturers of the rotary vibrating screen in the market said that the ultrasonic rotary vibrating screen runs for a long time, and sometimes abnormal noise occurs. The following are the possible reasons for the abnormal noise of the ultrasonic rotary vibrating screen .
The abnormal sound produced by the ultrasonic vibrating screen may be caused by a short circuit of the connecting line between the power supply of the equipment and the transducer; the plug of the connecting line is damp or broken down by conductive materials; if the transducer fails, you can use an electric meter to check the HF connection cable and Plug, so that the insulation resistance in the middle is not less than 1M. If the resistance is less than 1M, you need to replace the plug, and then use a multimeter to measure the capacitance value between the two lines of the transducer on the capacitance measuring gear. When the HF is connecting the cable and the transducer When the insulation resistance between the transducers is less than 3nf, it proves that there is at least one broken wire in the HF connecting cable to the transducer.
If you have other questions about the vibrating screen, you can contact us, and the professionals of Dayong Vibration Equipment Company will give you solutions.
