Installation and adjustment of vibrating screen/Stainless steel rotary vibro sieve
Rotary vibrating screens are widely used in chemical, pharmaceutical, food, abrasive, paint, glass, pollution treatment and other industries. After the vibrating screen arrives, installation and debugging are very important steps, which determine whether the screening machine can operate normally. Whether the screening effect is the best, the following is the installation and debugging of the vibrating screen.
This article mainly explains the debugging and precautions before the installation of the vibrating screen, and I hope it will be helpful to you.
If you have other questions about rotary vibrating screen, you can contact us, Dayong Vibration Equipment Company specializes in the production of screening and conveying machinery, and professionals will give you solutions according to your needs.
Rotary vibrating sieve are widely used in chemical, pharmaceutical, food, abrasive, paint, glass, pollution treatment and other industries. After the vibrating screen arrives, installation and debugging are very important steps, which determine whether the screening machine can operate normally. Whether the screening effect is the best, the following is the installation and debugging of the vibrating screen.
Preparation before installation
1. Check whether the motor signs meet the requirements.
2. Use a 500-volt megohmmeter to measure the insulation resistance. The value should be dried for the stator winding, and the drying temperature should not exceed 120 °C.
3. Check the fasteners of the motor to prevent loosening.
4. Check whether the motor surface is damaged or deformed.
5. Check whether the rotation is flexible. If there is any abnormality, it should be excluded.
6. Check the power supply, whether there is a phase loss, and run it for 5 minutes with no load.
installation and adjustment
1. The motor should be fastened on the installation surface, and the installation surface must be smooth and flat.
2. The motor can be installed horizontally.
3. The four-core rubber cable YZ-500V is used for the lead wire of the motor. When connecting the power supply, the lead wire and cable are not allowed to have a sharp break, and are reliably fixed with the vibrating body.
4. The motor should be grounded reliably. There is a grounding device in the motor, and the lead end has a mark. It can also be grounded with solid bolts on the feet.
5. Adjustment of exciting force.
If you have other questions about rotary vibrating screen, you can contact us, Dayong Vibration Equipment Company specializes in the production of screening and conveying machinery, and professionals will give you solutions according to your needs.
