Cause Analysis of Abnormal Damage of Vibrating Screen
During the use of the vibrating screen, there are often reasons for the damage of the vibrating screen. Generally, the reasons for the damage of the screen can be summarized as follows: the quality of the screen, the installation of the screen, the cause of the vibration motor, the cause of the accumulation of clay, etc. The professional personnel of the vibration equipment company are used to analyze the reasons for the damage of the screen mesh. This article mainly analyzes the reasons for the abnormal damage of the screen mesh, and proposes solutions.
During the use of the vibratory sieve , there are often reasons for the damage of the vibrating screen. Generally, the reasons for the damage of the screen can be summarized as follows: the quality of the screen, the installation of the screen, the cause of the vibration motor, the cause of the accumulation of clay, etc. Use the professional staff of the vibration equipment company to analyze the reasons for the damage of the screen:
1. Reasons for screen quality
The screen of the vibrating screen is usually divided into two parts, the screen layer and the force layer. These two layers must be closely attached before they can be used normally. When the stress layer at the bottom of the screen is tight, the screen layer is not tight, resulting in premature failure of the screen;
Solution: Buy a screen with good quality and excellent technology.
2. Reasons for screen installation
When installing the screen, if the tension of the screen is not enough, it does not meet the requirements of the screen installation, and the screen is not installed according to the instructions for use, which will cause the screen to vibrate, resulting in breakage or damage along the edge of the screen or the edge of the bead;
Solution: Strictly follow the instructions when installing the screen.
3. Reasons for vibration motor
When debugging the vibrating motor, some users think that the drill cuttings can move forward based on the experience of using the linear vibrating screen or the uniaxial vibrating screen, but this experience is not applicable to the translational elliptical vibrating screen. There is a force to roll backwards, and the forward speed of the drill cuttings will be much slower than normal, causing the material to stay on the screen for too long, and even unable to remove the drill cuttings, resulting in premature damage to the screen.
